Standard Test Methods for Dry Abrasion Mar Resistance of High Gloss Coatings.
- This test method covers procedures for evaluating the relative mar resistance of high gloss coatings. Two test methods are included. Test Method A uses a device that contains a rotating specimen holder and two abrasive wheels. Test Method B uses a device that contains a reciprocating specimen holder and a single wheel that has been fitted with abrasive paper. Either method can be used to evaluate the dry abrasion mar resistance of coatings applied to planar, rigid surfaces. Each test method provides good discrimination between highly mar resistant coatings.
- Note: The mar resistance values obtained by these test methods have no absolute significance. They should only be used to derive relative performance rankings for test panels that have been prepared from the series of coatings that are currently being evaluated. If mar resistance values are quoted between laboratories, it is essential that a common standard be measured and that the values be compared to that standard. Even then, the values should be used with caution.
- The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
- This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
TABER® ROTARY ABRASER - MODEL 1700/1750
“Taber Test” delivers reliable data in minutes. Used to evaluate a material’s resistance to wear, a flat specimen...read more
TABER ROTARY ABRASER 5135 & 5155
The Taber Abraser (Abrader) is used to conduct accelerated abrasion and wear resistance tests on flat specimens. Samples...read more